Sept 10 - 20, 2013
Head light covers and Diffuser were installed. The spacers that Factory five supplied for the diffuser just did not look very good. They were about 3/8" and I wanted something a little wider. I had some 1/2" (.049 wall) I cut them to size and used the ones supplied as a spacer or insert. Also tried a 5/8 piece of aluminum as one of the spacers but I think I like the 1/2" stainless tubing better.
Aug 20-26, 2013
I was able to sand out the head light buckets to get the high and low beams installed. the drivers side signal light had to be sanded out a little to get it to fit. I will have to add some fiber glass to get the nice finish.